We get this question quite a bit and unfortunately the "right" answer tends to either get people confused or make them irritated. Let me explain…

When applying granules over turf, the correct application will distribute a certain "pre-determined amount of product" over a "pre-determined area of turf". To get these two pre-determined values, you first need to know the "total" area you'd like to treat. For this example, we'll say 4150 sq/ft. I chose this number because it's right at 1/2 of what a 10 lb bag of MERIT GRUBZ OUT will treat. This means it would take about 5 lbs to treat this 4150 ft total we're using in our example. So now we know the total amount of product needed and the total amount of turf this product will cover. Next we need to accurately measure out 5 lbs of granules and 4150 sq/ft of yard before we begin the actual application. For the granules, this is easy to do. Since it comes packaged in a 10 lb bag, 5 lbs would be about 1/2 of the bag. Now you need to figure out how large the various "sections" are in your yard so you'll be able to monitor the application and know you're applying the right amount to the right amount of yard. For this measurement, it's best to try and measure length times width since this is easier to add up compared to circles. In most cases this can be done by dividing the yard into squares or rectangles. For example, a section that's 41 ft wide by 1000 ft long would span 4100 sq/ft (and close to the amount 5 lbs of granules will treat). Once you've got your "yard sections" identified and "marked", you may move on to the next step…

Which brings us back to your original question: "what the EZ BROADCAST setting might be for grubz out"? Well obviously it's the setting that will get the 5 lbs of granules equally distrbibuted over the 4150 sq/ft we need to treat! Now do you see how this answer might make some people either confused or irritated? Yet it's really quite accurate in that there is no magical number or setting that will get the job done correctly for every person that might attempt to do such a treatment. Clearly people walk at many different rates and they all twist the spreader handle at different speeds so how in the world does anyone get it right? Well, for starters it's not an exact science…

In reality there is no "right" or "wrong" setting. As long as you get it real close to being "equally distributed" over the targeted turf, chances are high your effort will be spot on and effective. With that being said, I always recommend people experiment with low settings at first. This way if they're applying it too slowly they can always increase the rate. But if you start with too high of a setting, you're not able to adjust once you realize your mistake. This is because you'll probably have had applied most of the granules by the time you realize your mistake. So avoid this from happening and start with a low to medium setting.

Additionally, it's best to start with a small section of turf you know size wise along with how much product will be needed to treat it. And I know, we've already decided these values would be 5 lbs and 4150 sq/ft. But what I mean here, being that this is the first time you'd be using this equipment and this product, is that it would be wise to make these amounts even smaller. Since we know 5 lbs will treat 4150 sq/ft it also means 2.5 lbs would treat about 2075 sq/ft and 1.25 lbs would cover around 1038 sq/ft. This 1038 is a good small number and one I would recommend you start with for your first application. That means you'll need just 1.25 lbs of granules.

Now position yourself in clear view of the 1038 sq/ft along with the 1.25 lbs of granules and get ready to work. Start by walking briskly and attempt to get the 1.25 lbs distributed over the 1038 sq/ft watching carefully as you proceed. In most cases you should get a "feel" for what's happening and then adjust either your speed of pace or the spreader setting to keep the goal obtainable. Since I know my yard so well, I can tell when a setting is too large or small within 15-30 seconds and I'll adjust it once I can tell. Ideally I like the spreader setting to enable me to walk at my normal pace. This way you can tend to the task in a comfortable manner. True, some people don't mind walking briskly so for them, a higher setting is most likely needed. But then someone who is moving slow could do just as well with a lower setting. The point here is you can be flexible with the setting as long as you get the right amount of product out over the right amount of turf!

So when you're walking, be sure to keep a steady crank pace along with a steady walking speed. Note when you've got about 1/2 of the granules applied and stop to check to see that you've covered about 1/2 of the 1038 sq/ft you were targeting. This might seem tedious and a pain but it's the best way to start when using a new spreader or product. The good news is once you get the right "rate" (walking and turning of the crank), it's something you'll remember and should be able to duplicate over and over. In the end you'll be able to fill the spreader without having to measure what you've poured out and get right to work without all these extra measurements. This will happen because you'll know the setting based on your normal rate/speed and your previous "applications". For me, I always just start slow and increase it as I see fit since going back over a treated area to apply more is always an option. However, as stated before, once it's out there you can't pick it back up (at least not easily!!)

Sorry for the long winded answer but I've been meaning to better explain this process so we can use this answer for future inquries. Give it a shot; I'm sure you'll figure out the right setting for your rate of walking with the spreader combined with the speed at which you like to turn the crank. And if you need any more help or guidance, give us a call on our toll free 1-800-877-7290.

What is the volume capacity of your SCATTER BOX SPREADER?

Thanks

Can you let me know which item numbers would work for me?

There are two or three sprayers that can help here. The most popular one is the TROMBONE SPRAYER. It's excellent for use outside and when you need to reach trees or house siding 25 feet up or higher. View the video on the Trombone page to see just how well this unit works.

Some people opt to use a HOSE END SPRAYER. When hooked to a garden hose with significant water pressure, the 6 GALLON or 20 GALLON can reach 20 feet or higher.

Lastly, the SOLO HD fitted with a VALVE CAP can be pressurized above the normal 45 lbs to enable it to reach higher. Just be forewarned that these tanks are only tested to hold up to 100 lbs so don't over inflate them or they'll break for sure. I have used them pumped up to 60-70 lbs and they can spray 20-25 feet. This has come in a handy a few times but isn't something I'd recommend doing all the time. For a pure pinstream, this would be your best option. The Hose End options as well as the Trombone will both put out a lot more product and it won't be nearly as tight as the Solo Pump Sprayer.

thanx!

t.c.

N7C can be applied many ways. It's non hazardous to people, pets and the environment so there is no danger when coming in direct contact with the concentrate. Even so, we always recommend using some RUBBER or SURGICAL GLOVES anytime you're working with one of our products. If wearing gloves, you'd be able to apply the N7Z with a sponge or rag directly to the area you need to deodorize. Just mix it up in a bucket and apply it by hand if you have direct access to the area needing treatment.

If the area is large or inaccessible, consider either a PUMP SPRAYER or a good mister/fogger option like the BG2300 or the FOGMASTER 6309. If you don't want to purchase the fogger, we have some for rental. Just give us a call on our toll free 1-800-877-7290 for further details.

Fogging or misting the N7Z is best suited when treating attics and spaces above living areas. This way it's not likely any material will leak down through the ceiling which can happen when using a pump sprayer and some "puddling" occurs when spraying. Using a Pump Sprayer is well suited for lower level applications like crawl spaces and basements where the spray is likely to be absorbed and the problems associated with puddling won't mean anything.

Lastly, if the odor is in a wall void, the FOAMING TOOL may be your best option and well worth the investment.

We've got several wands that can work on your Solo Sprayer.

24" Plastic Extension

23-40" Brass Extension

24" Plastic Boom

60" Brass Extension

Give us a call on our toll free 1.800.877.7290 and we'll answer any questions and get you set up with the right one.

The best sprayer for your need is really based on two things. First, how high you want to reach and second, how good of quality you'd like to have in a sprayer.

If your main need is to spray high on the exterior of your home, consider the TROMBONE or one of HOSE END SPRAYERS. These are specialized sprayers which can reach quite high but they are not so practical for regular monthly treatments where you may only be spraying 1-2 gallons of finished product. The Trombone is ideal for big jobs where a lot of product needs to be distributed over large areas. Hose end sprayers are similar but less efficient using more chemical and tend to waste more as well. Better suited for lawns, Hose End Sprayers should only be considered if you just need it to do the job and cost is a factor.

If you'd like a more "rounded" sprayer that will be better suited for a wide range of pest control treatments, the ELMINATOR is Ok and adequate for reaching 10 feet or a little higher. But keep in mind it's a true "entry" level type sprayer and isn't expected to last that long or provide the best of spraying experiences. A more refined, higher quality sprayer would be either the SOLO 1 GAL HD or the SOLO 2 GAL HD. These are very durable, strong and designed to last many years. The ROLL ABOUT 2 GALLON is the same sprayer but mounted on wheels.

Any of these and several more found at www.gotosprayer.com are more than adequate for the job you need done. Go to the site and if after further review you're still confused, give us a call and we'll be glad to assist. Our toll free is 1.800.877.7290.

Checking for a suitable mister to spray a 50 ft. trailer after unloading dirty linen.

If you can please advise or provide a quote would be great.  Is there a Canadian supplier for your products?  We have been using a B & G model 2400 but it doesn't not have much life left.

I'm not sure about any local suppliers but I do know we carry a few options that would handle this job quite well. If you browse to our FOGGERS page, you'll see the links for the models we carry in 240 volts. This list includes the FM 6309, the FM 6208, the FM 7807 and even the FM 5330 Mini Fogger.

Unfortunately these all vary so much in weight and packaging it would be a lot of work to get quotes considering all the options. If you can review the list I've posted and let me know which you think will work best, it would help narrow the field. We could then e-mail some quotes. Alternatively, we can call you at a good time or you can give us a call on either our toll free 1.800.877.7290 or 770.985.9392. At that time our reps will be able to work through the screens and get a shipping quote a lot faster. I do know we ship to Canada quite a bit via all the major carriers so getting one from us is entirely possible.

1.  I live in Sandy Springs.  Could I pick up my order at your Lilburn location instead of having it delivered by mail?
2.  You recommend 1/2 corks to plug up Carpenter Bee galleries.  Is there a significant benefit to using corks over wood putty?

Thank you.

First, you can come by our store during regular business hours and pick up your order. Store hours and our location can be seen here:

http://www.gotosprayer.com/about-us/corporate-location

Second, there is some benefit of using corks over putty. The main reasons are posted in here:

http://www.carpenterbees.com/seal/sealing-carpenter-bee-holes-with-caulking.html

Our beesuits use a mix of cotton and polyester called VISA. This extremely durable material will last for many years. It also does a great job of keeping you cool by wicking away moisture from the inside out.

We have several options that should help. First, all our HOSE END SPRAYERS can spray 20 feet or more as long as you have sufficient water pressure. At my house, I'm able to spray almost 30 feet up with 3-4 of the models featured on the page above.

Additionally, we have several PUMP SPRAYERS that can spray 15-20 feet up so you have some options with this design as well.

Lastly, the TROMBONE SPRAYER is another good option and is very handy if you have trees and other vegetation that needs to be treated from time to time.