sprayer that can reach 30 feet or higher

I am looking for a sprayer to use in applying fruit eliminator (e.g. Florel) to a sweet gum tree. I think the tree is about 30 feet high and the hose end sprayers I have don’t seem to have one that can reach. What do you have in your product line that might do this job better?

We get this question quite often. The best option is our Trombone Sprayer which works off mechanical energy. View the video on the Trombone Sprayer page and you’ll see how it works and how high it can spray. The second option is to get our Solo 1 Gallon HD or Solo 2 Gallon HD and do some “tinkering”. We can’t “recommend” doing this (in case you damage something) but it will enable you to get more pressure into either sprayer for special situations where you need to reach extra high. Each of these sprayers has a pressure relief valve on the top of the tank (opposite the hose connection) which acts as a “pressure governor”. This governor will only allow a certain amount of pressure to build up in the tank when you pump it up. By replacing this valve with a valve cap, you can manually pump up the sprayer more than normal. This increase of pressure will enable you to reach higher when spraying. I have been able to get the pressure high enough to reach over 30 feet but it does require a lot of force to pump to get it this pressurized. I’m guessing if you used the sprayer like this all the time it would lead to a faster breakdown of some gaskets but I haven’t seen any real impact on mine after doing this a few times. The other concern I have is that when pumping with the handle you must take care not to damage the pump by pushing too hard on an angle. Be sure to direct the force straight down so the pump rod doesn’t bend or break. But since you really only need 60-80 lbs of pressure to get it to spray over 30 feet up, there shouldn’t be any problems if you do the pumping with the sprayer on a flat surface and restricting it tightly so it can’t shift around. The tank is rated for over 200 lbs of pressure so you can’t manually explode it when pumping it with your arms. For now, these are our two options.

Thermal hot fogger

I want to do some fogging on my property for mosquitoes and I’ve heard a hot thermal fogger is the way to go. I’ve got about 1/2 acre to treat. I’ve looked at some models but they all seem very expensive. Do I really need to use a thermal fogger to get good control?

Definitely not. Thermal foggers do offer some advantages over cold, misting type fogging machines but this advantage usually won’t pay for itself unless you were treating a large area. Since thermal foggers can treat large areas rapidly and more effiiciently than a cold fogger, they’re better suited when treatments will be done to areas which are in excess of any acre. For 1/2 acre, you’ll be able to get fine results with the B&G 2300 or the Fogmaster 6208. Though “cold”, they produce a fine mist which is more than adequate for most applications. And yes, you’ll use a little more chemical when treating with either of these but the difference is nominal at this scale.

Solo 2 gallon foamer

I have a slab I want to treat for a bad springtail infestation and I’m thinking using foam might help. The solo 2 gallon foamer looks like it will create a nice thick foam. Is this what you would recommend?

Springtail control can be tough – especially when they get up under a slab. The bottom line is that springtails migrate in such tremendous numbers they can be almost impossible to stop unless you get them where they’re nesting. Many times this is in the soil which is easy to treat. But if they start nesting under a slab, it can be extra tough. For such situations, we always recommend foaming. This insures the treatment will reach the bottom side of the slab which is where they like to roost. And be sure to treat more than just the side that touches the house. Since they are most likely living under the entire slab, if you don’t treat the whole area you’ll keep having them emerge through the treated soil because you haven’t successfully killed them all yet.